MOBILE
|
|
|
Mobile module |
4G
(LTE) - LTE Cat 4 150 Mbps DL, 50 Mbps UL; 3G - 21 Mbps DL, 5.76 Mbps UL; 2G
- 236.8 kbps DL, 236.8 kbps UL |
|
SIM switch |
2
SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no
network, network denied, data connection fail, SIM idle protection |
|
Status |
IMSI,
ICCID, operator, operator state, data connection state, network type,
bandwidth, connected band, signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO,
RSCP, data sent/received, LAC, TAC, cell ID, ARFCN, UARFCN, EARFCN, MCC,
and MNC |
|
SMS |
SMS
status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS
to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP |
|
USSD |
Supports
sending and reading Unstructured Supplementary Service Data messages |
|
Black/White list |
Operator
black/white list (by country or separate operators) |
|
Band management |
Band
lock, Used band status display |
|
APN |
Auto
APN |
|
Bridge |
Direct
connection (bridge) between mobile ISP and device on LAN |
|
Passthrough |
Router
assigns its mobile WAN IP address to another device on LAN |
ETHERNET
|
|
|
LAN |
2
x ETH ports (can be configured as WAN), 10/100 Mbps, compliance with IEEE
802.3, IEEE 802.3u, 802.3az standards, supports auto MDI/MDIX crossover |
POE IN
|
|
|
PoE ports |
1
x PoE In |
|
PoE standards |
802.3af/at |
POE OUT
|
|
|
PoE ports |
1
x PoE Out |
|
PoE standards |
802.3af
Alternative B |
|
PoE Max Power per Port (at
PSE) |
15
W Max (power supply unit dependent) |
NETWORK
|
|
|
Routing |
Static
routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, EIGRP, NHRP), Policy based
routing |
|
Network protocols |
TCP,
UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP,
VRRP, PPP, PPPoE, UPNP, SSH, DHCP, Telnet, SMPP, SNMP, MQTT, Wake On Lan
(WOL) |
|
VoIP passthrough support |
H.323
and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets |
|
Connection monitoring |
Ping
Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection |
|
Firewall |
Port
forward, traffic rules, custom rules |
|
Firewall status page |
View
all your Firewall statistics, rules, and rule counters |
|
Ports management |
View
device ports, enable and disable each of them, turn auto-configuration on or
off, change their transmission speed, and so on |
|
Network topology |
Visual
representation of your network, showing which devices are connected to which
other devices |
|
DHCP |
Static
and dynamic IP allocation, DHCP relay, DHCP server configuration, status,
static leases: MAC with wildcards |
|
QoS / Smart Queue Management
(SQM) |
Traffic
priority queuing by source/destination, service, protocol or port, WMM,
802.11e |
|
DDNS |
Supported
>25 service providers, others can be configured manually |
|
Network backup |
VRRP,
Wired options, each of which can be used as an automatic Failover |
|
Hotspot |
Captive
portal (hotspot), internal/external Radius server, Radius MAC authentication,
SMS authorisation, internal/external landing page, walled garden, user
scripts, URL parameters, user groups, individual user or group limitations,
user management, 9 default customisable themes and optionality to upload and
download customised hotspot themes |
|
SSHFS |
Possibility
to mount remote file system via SSH protocol |
SECURITY
|
|
|
Authentication |
Pre-shared
key, digital certificates, X.509 certificates, TACACS+, Radius, IP &
login attempts block, time-based login blocking, built-in random password
generator |
|
Firewall |
Pre-configured
firewall rules can be enabled via WebUI, unlimited firewall configuration via
CLI; DMZ; NAT; NAT-T |
|
Attack prevention |
DDOS
prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack
prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN
scan attacks) |
|
VLAN |
Port
and tag-based VLAN separation |
|
Mobile quota control |
Mobile
data limit, customizable period, start time, warning limit, phone number |
|
WEB filter |
Blacklist
for blocking out unwanted websites, Whitelist for specifying allowed sites
only |
|
Access control |
Flexible
access control of SSH, Web interface, CLI and Telnet |
VPN
|
|
|
OpenVPN |
Multiple
clients and a server can run simultaneously, 27 encryption methods |
|
OpenVPN Encryption |
DES-CBC
64, RC2-CBC 128, DES-EDE-CBC 128, DES-EDE3-CBC 192, DESX-CBC 192,BF-CBC 128,
RC2-40-CBC 40, CAST5-CBC 128, RC2-64-CBC 64, AES-128-CBC 128, AES-128-CFB
128, AES-128-CFB1 128, AES-128-CFB8 128, AES-128-OFB 128, AES-128-GCM 128,
AES-192-CFB 192, AES-192-CFB1 192, AES-192-CFB8 192, AES-192-OFB 192,
AES-192-CBC 192, AES-192-GCM 192, AES-256-GCM 256, AES-256-CFB 256,
AES-256-CFB1 256, AES-256-CFB8 256, AES-256-OFB 256, AES-256-CBC 256 |
|
IPsec |
IKEv1,
IKEv2, with 14 encryption methods for IPsec (3DES, DES, AES128, AES192,
AES256, AES128GCM8, AES192GCM8, AES256GCM8, AES128GCM12, AES192GCM12,
AES256GCM12, AES128GCM16, AES192GCM16, AES256GCM16) |
|
GRE |
GRE
tunnel, GRE tunnel over IPsec support |
|
PPTP, L2TP |
Client/Server
instances can run simultaneously, L2TPv3, L2TP over IPsec support |
|
Stunnel |
Proxy
designed to add TLS encryption functionality to existing clients and servers
without any changes in the program’s code |
|
DMVPN |
Method
of building scalable IPsec VPNs |
|
SSTP |
SSTP
client instance support |
|
ZeroTier |
ZeroTier
VPN client support |
|
WireGuard |
WireGuard
VPN client and server support |
|
Tinc |
Tinc
offers encryption, authentication and compression in it's tunnels. Client and
server support. |
OPC UA
|
|
|
Supported modes |
Client,
Server |
|
Supported connection types |
TCP |
MODBUS
|
|
|
Supported modes |
Server,
Client |
|
Supported connection types |
TCP |
|
Custom registers |
MODBUS
TCP custom register block requests, which read/write to a file inside the
router, and can be used to extend MODBUS TCP Client functionality |
|
Supported data formats |
8-bit:
INT, UINT; 16-bit: INT, UINT (MSB or LSB first); 32-bit: float, INT, UINT
(ABCD (big-endian), DCBA (little-endian), CDAB, BADC), HEX, ASCII |
DATA TO SERVER
|
|
Protocol |
HTTP(S),
MQTT, Azure MQTT |
|
Data to server |
Extract
parameters from multiple sources and different protocols, and send them all
to a single server |
|
MQTT GATEWAY
|
|
|
Modbus MQTT Gateway |
Allows
sending commands and receiving data from MODBUS Server through MQTT broker |
|
DNP3
|
|
|
Supported modes |
Station,
Outstation |
|
Supported connection |
TCP |
DLMS
|
|
|
DLMS Support |
DLMS
- standard protocol for utility meter data exchange |
|
API
|
|
|
Teltonika Networks Web API
(beta) support |
Expand
your device's possibilities by using a set of configurable API endpoints to
retrieve or change data. For more information, please refer to this
documentation: https://developers.teltonika-networks.com |
MONITORING & MANAGEMENT
|
|
WEB UI |
HTTP/HTTPS,
status, configuration, FW update, CLI, troubleshoot, multiple event log
servers, firmware update availability notifications, event log, system log,
kernel log, Internet status |
|
FOTA |
Firmware
update from server, automatic notification |
|
SSH |
SSH
(v1, v2) |
|
Email |
Receive
email message status alerts of various services |
|
SMS |
SMS
status, SMS configuration, send/read SMS via HTTP POST/GET |
|
Call |
Reboot,
Status, Mobile data on/off, Output on/off, answer/hang-up with a timer |
|
TR-069 |
OpenACS,
EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech,
AVSystem |
|
MQTT |
MQTT
Broker, MQTT publisher |
|
SNMP |
SNMP
(v1, v2, v3), SNMP Trap |
|
JSON-RPC |
Management
API over HTTP/HTTPS |
|
RMS |
Teltonika
Remote Management System (RMS) |
IOT PLATFORMS
|
|
|
Cloud of Things |
Allows
monitoring of: Device data, Mobile data, Network info, Availability |
|
ThingWorx |
Allows
monitoring of: WAN Type, WAN IP, Mobile Operator Name, Mobile Signal
Strength, Mobile Network Type |
|
Cumulocity |
Allows
monitoring of: Device Model, Revision and Serial Number, WAN Type and IP,
Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength |
|
Azure IoT Hub |
Can
send device IP, Number of bytes send/received, Temperature, PIN count to
Azure IoT Hub server, Mobile connection state, Network link state,
IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, SIM State, PIN
state, GSM signal, WCDMA RSCP, WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ,
CELL ID, Operator, Operator number, Connection type |
SYSTEM CHARACTERISTICS
|
|
CPU |
Mediatek,
580 MHz, MIPS 24KEc |
|
RAM |
128
MB |
|
FLASH storage |
16
MB |
|
FIRMWARE / CONFIGURATION
|
|
WEB UI |
Update
FW from file, check FW on server, configuration profiles, configuration
backup |
FOTA |
|
|
Update
FW |
RMS |
|
Update
FW/configuration for multiple devices at once |
|
Keep settings |
Update
FW without losing current configuration |
|
Factory settings reset |
A
full factory reset restores all system settings, including the IP address,
PIN, and user data to the default manufacturer's configuration |
FIRMWARE CUSTOMISATION
|
|
Operating system |
RutOS
(OpenWrt based Linux OS) |
|
Supported languages |
Busybox
shell, Lua, C, C++, and Python, Java in Package manager |
|
Development tools |
SDK
package with build environment provided |
|
GPL customization |
You
can create your own custom, branded firmware and web page application by
changing colours, logos, and other elements in our firmware to fit your or
your clients’ needs
|
